evolution
07-15-2010, 11:11 PM
well, i will describe the best i can..since i put the new lift on i went with a jb conv. sye, tom woods driveshaft. the only thing i changed in the rearend was the chromoly shafts..
its in between them 3, its a clunking noise like the driveshaft is binding just a lil if you can see what im talking bout, i took it out and it did not have any marks where it was and it has plenty of droop left in the shaft... ive also took the rearend cover off to see if anything came apart, put the jeep on jack stands and had the wife run it thru the gears and i listened and tried to pin point where it came from.
it only happens when theres a load on the rearend, ive never had a pinion bearing go out or start and is just wondering if that may be what is happening..
its in between them 3, its a clunking noise like the driveshaft is binding just a lil if you can see what im talking bout, i took it out and it did not have any marks where it was and it has plenty of droop left in the shaft... ive also took the rearend cover off to see if anything came apart, put the jeep on jack stands and had the wife run it thru the gears and i listened and tried to pin point where it came from.
it only happens when theres a load on the rearend, ive never had a pinion bearing go out or start and is just wondering if that may be what is happening..