Project Punisher - 1995 YJ

[bajonesy77]

damn thats gonna be a big jeep! good luck with the interview bro.

[YJeXtreme]

figure after body lift is cut down to about 3/4" & spring packs are softened up it'll set about 3-4" lower overall. still gonna be a beast though. Also got some new decals on order for it.... should have em in about a weekl.

[MikeB78]

Good luck with the interview man, trust me I know how bad it sucks to keep going to a job you hate every day. Funny thing is that you are trying to get out of HSN while I am trying to get in. Im supposed to know something by Friday from them. Once again good luck

[xjmudman96]

That thing is a beast. All I need is an adjustable track bar to put my front end back up where it's supposed to be, but I found myself looking for a new job as well. So for now still riding like a redneck. It's like 3" higher in the rear.
Hopefully we'll all be right come spring cause it looks like we got another month of winter @least

[YJeXtreme]

Got gas tank back in today, and front springs apart, and back together. Really softened 'em up like I wanted, similar to the 2" YJ Springs I was previously going to run. Ordered my Hub assemblies tonight, and will be going to Roanoke Spring works for my U-bolts tomorrow. Saturday hope to have it on wheels for first time in way too many months.

[YJeXtreme]

Got my hubs, but forgot to budget out for new Wheel studs, and wheel bearings... Picked up the waggy springs from Brett today, and installed them. They need to be rearched, they've sagged out about an 1" Did get the rear back in, and tires bolted up, and on the ground. Didn't get a change to start removing flairs and marking my cut lines. Will wait til body lift is removed to get it right.

[evolution]

let me know i can rearch them springs for ya.. im not sure what noke springs works cost..

[YJeXtreme]

Thanks bro, but Roanoke Spring only gonna charge $32 or so, which is cheaper than the gas to and from your place to drop 'em off and pick 'em up. Will get them done soon.

Trying to get Autocad installed so I can design shackle reversal mounts... I refuse to pay over $300 for M.O.R.E.'s kit. It's just 4 pieces of 1/4" plate cut and welded to a piece of 1/4" thick angle. I can steal measurements from my buddies YJ.

[YJeXtreme]

Some boredom w/ Autocad, designed the Front Ubolt plates to fit the Dana 44, since driver side is diff due to spring perch cast into housing.

[YJeXtreme]

spent today fixing the ground wires on my harness. Headlights, horn & signal lights all working now. Fuel pump primes with key on. Starter still not engaging... Still some wire tracing to do... Gonna try to finally get it fired this weekend...